LĒVO I: Getting Started & Setting Up

Updated 6 months ago by LĒVO

LĒVO I: Getting Started & Settings

Welcome to LĒVO! Now that you bought the machine that makes home infusion simpler, let's set it up!

Our LĒVO I machines have now been replaced by the LĒVO II - check out the LĒVO II here!

When starting a cycle, the LĒVO will display a default time and temperature setting. The default setting can be adjusted as necessary within the range shown below: 

Default Setting 150ºF /65ºC for 2 hours           

Minimum/Maximum Setting 75º- 200ºF up to 10 hours

Set Up your LĒVO I:

  1. Remove all outer and inner packaging from the LĒVO
  2. Set the LĒVO on a flat & sturdy surface and plug the power cord into an electrical outlet
  3. Press and swipe the POWER button downwards to turn the machine on
  4. Open the lid by pressing down on it gently to release the spring latch
  5. Rinse the removable parts inside the LĒVO with warm, soapy water and dry before replacing them
    1. Metal reservoir & attached silicone nozzle - To remove the metal reservoir from the LĒVO, hold down the RELEASE button on the keypad while lifting it UP and out
    2. Silicone stirrer
    3. Standard herb pod with cap
  6. Make sure the silicone nozzle is securely attached to the reservoir's spout and place back inside the LĒVO
    1. Hold down the RELEASE button on the keypad while lowering the reservoir down into place, directing the nozzle through the drain opening. Let go of the RELEASE button when the reservoir is securely in place
  7. Place the magnetic stirrer inside the reservoir on the center 'bump'
    1. Ensure that the stirrer magnetically aligns in the center of the reservoir (should not be off-center)
  8. Place the standard herb pod inside the reservoir beside the PLACE POD HERE guideline
    1. The herb pod’s bracket will magnetically cling to the reservoir at that marking.
  9. Set your temperature reading to display in either Celsius or Fahrenheit
    1. Toggle between Celsius and Fahrenheit by holding down the temperature '+' and '-' buttons at the same time for 1 second
  10. LĒVO's sounds are on by default. We think you'll like them. However, you can mute all sounds by pressing time '+' and '-'  for 1 second

Use our Oil & Herb Calculator for INFUSE setting recommendations based on your type of ingredients

The default settings are just suggestions based around most common use cases. Other factors should be considered when setting the time and temperature, like your environment (ie. altitude), the type of ingredients you are using, and the end result you desire


How did we do?