Welcome to LEVO! Now that you bought the machine that does it all, let's get into the simple steps to Set Up your LEVO II for first use!
- Remove all outer and inner packaging from the LEVO.
- Set the LEVO on a flat & sturdy surface and plug the power cord into an electrical outlet.
- Press and hold the POWER button to turn the LEVO on.
- Open the lid by pressing down on it gently to release the spring latch.
- Rinse the removable parts inside the LEVO with warm, soapy water and dry before re-placing.
- Metal reservoir & removable silicone nozzle
- Silicone stirrer
- Double herb pod & cap
- Pod protector
*To remove the metal reservoir from the LEVO, press and hold the RELEASE button under the lid while lifting it UP and out.
- Make sure the silicone nozzle is securely re-attached to the reservoir's spout and place back inside the LEVO.
- Hold down the RELEASE button under the lid while lowering the reservoir down into place, directing the nozzle through the drain opening.
- Pressing the RELEASE button once will open the drain valve for 7 seconds; or you can press and hold for as long as necessary.
- Place the magnetic stirrer inside the reservoir on the center 'bump'.
- Ensure that the stirrer magnetically aligns in the very center of the reservoir (should not be off-center).
- Ensure that the stirrer magnetically aligns in the very center of the reservoir (should not be off-center).
- Place the double herb pod inside the reservoir beside the PLACE POD HERE guideline.
- The herb pod’s bracket will magnetically cling to the reservoir at that marking.
- The pod protector should be placed inside the bottom of the double herb pod before adding any ingredients for DRY or ACTIVATE cycles.
- Set your temperature reading to display in either Celsius or Fahrenheit.
- Toggle between Celsius and Fahrenheit by holding down the temperature '+' and '-' buttons at the same time for 1 second.
- LEVO's sounds are on by default. We think you'll like them. However, you can mute all sounds by pressing time '+' and '-' for 1 second.